Note: For some non-cargo management system vehicles, the jack and tools are located in the right rear of the cargo area behind an access panel. To remove a fuse use the fuse puller tool provided on the fuse panel cover. Consult your dealer for information on other Ford approved methods of traction control. An unbalanced tire and wheel assembly may result in irregular tire wear. Install and tighten the fill plug securely.
Hitches Do not use hitches that clamp onto the vehicle bumper. If the fuel filler cap is venting vapor or if you hear a hissing sound, wait until it stops before completely removing the fuel filler cap. Information on transfer case operation and shifting procedures can be found in the Driving chapter. Manufacturer identification is located at the end of the webbing on the label. To stop motion at any time during the one-touch opening, press the control a second time. To adjust the cross-bar assembly on the inner rack: 1. Pull down on the shoulder belt and then grasp the shoulder belt and lap belt together.
Your Audiophile radio comes equipped with Satellite ready capability. When a wheel is installed, always remove any corrosion, dirt or foreign materials present on the mounting surfaces of the wheel or the surface of the front disc brake hub and rotor that contacts the wheel. Belts are Ford designs its safety belts to enhance comfort. If your vehicle requires professional service, your dealership can provide the necessary parts and service. Don't waste time calling around to your local bookstores or waiting for a repair manual to arrive by mail. State or local regulations on volatile organic compounds may restrict the use of methanol, a common windshield washer antifreeze additive. Make sure the tongue is latched securely by pulling on it.
Use of these systems may result in vehicle starting problems and a loss of security protection. The system is designed to help protect smaller drivers sitting close to the driver airbag by providing a lower airbag output level. In the United States, a warranty dispute must be submitted to the. For load specification terms found on the label, refer to Vehicle loading in this chapter. Turn all other accessories off. Important child restraint precautions You are required by law to use safety restraints for children in the U. Push control to lower or remove head restraint.
Ford recommends the use of a child safety seat having a top tether strap. To reset the switch: 1. Locate the bulb that is the most center in the vehicle and remove the electrical connector by pulling it straight off. The Safety Canopy is mounted to roof side-rail sheet metal, behind the headliner, above the first and second row seats. Check seat covers and buckles before you place a child anywhere near them. Refer to Lubricant specifications in this chapter.
The kit to enable the Satellite reception is available through your Ford dealer. Stop the vehicle as soon as safely possible, switch off the engine and let the engine cool. Utility vehicles and trucks are not designed for cornering at speeds as high as passenger cars any more than low-slung sports cars are designed. As the belt retracts, you will hear a clicking sound. Follow the same steps to replace either bulb: 1.
Traction control and four wheel drive is great, even if it has only a v-6. Lower the inner rack by pivoting at the hinges of the rack. Ensure the vehicle is electronically unlocked. The horn will chirp one time to confirm the programming mode has been exited. Department of Transportation-Tire quality grades: The U. Loaded vehicles may handle differently than unloaded vehicles.
Locate and carefully remove the engine oil level indicator dipstick. Do not place any objects on the cargo area shade. Your radio comes equipped with Satellite ready capability. Fan speed adjustment: Controls the volume of air circulated in the vehicle. Only use a washer fluid that meets Ford specifications. Rotate the handle on the lift bar of the inner rack in the direction of the arrows on the handle and pull the inner rack away from the bumper.
If uncomfortable you are uncomfortable - try different positions for the safety belt upper anchorage and seatback which should be as upright as possible;. Refer to the diagram inside the remote entry transmitter for the correct orientation of the battery. Safety restraints precautions Always drive and ride with your seatback upright and the lap belt snug and low across the hips. The use of tire sealants may damage your tires. Box 1580, Station B, Mississauga, Ontario L4Y 4G3. The cover may cause injury in a sudden stop or accident if it is not securely installed. Do not tow with a slingbelt.
The lighter will be released from its heating position when it is ready to be used. Replacing high-mount brake lamp bulbs To remove the lamp assembly: 1. If the side airbag has deployed, the airbag will not function again. If it enters the red section, the engine is overheating. Protect yourself from engine heat. The fuel gauge may vary slightly when the vehicle is in motion or on a grade. If the engine idle speed does not slow down automatically, have the vehicle checked.