Relying too much on your right side mirror could cause you to collide with another vehicle or other object. Utility vehicles have a significantly higher roll over rate, ground clearance, higher center gravity, narrower, driven in an unsafe manner, all vehicles can be caused, and the narrower track, if this vehicle is out control it. Make sure the sides of the top are folded inward as the top continues to fold, and check straps are clear of the vehicle. Make sure the nylon check straps between the 2 bow and 3 bow are not twisted or wrapped around the 2 bow. Not required if belt was previously replaced. Use the heater when temperatures below 0°F -18°C are expected to last for several days. Visa, Mas- tercard, American Express, and Discover orders are ac- cepted.
Tuck the sail panel retainer into the bodyside retainer. To activate the front fog lights, turn on the parking or low beam headlights and pull out the end of the lever. Run the upper zipper around the window to the right side leaving the lower zipper end at the start on the left. It allows you to stay comfortable while keeping the windshield clear. Most matters can be resolved with this process.
Engage the hooks on each side of the header into the windshield slots and fully engage the header latches. The coldest setting is to the extreme left blue region and the warmest setting is to the extreme right red region. Refer to Fluids, Lubricants, and Genuine Parts for correct fluid type. Its round headlights, jailhouse grille, and sq-edged fenders hark returning to the 1940 initial. Grasp the header and lift the top back.
Lubricate the steering and suspension ball joints. Not required if belt was previously. Inspect the engine air filter element, replace if necessary. Answered on Dec 22, 2014. Tuck the lower retainers of the rear window under the tailgate clips. Pull the side bow forward and down. Unclip and move the sun visor to the side.
This is a specialized utility vehicle designed for both on-road and off-road use. Unintended movement of a vehicle could injure those in and near the vehicle. Make sure the material is folded back as shown. Keep the blade rubber out of contact with petroleum products such as engine oil, gasoline, etc. In a collision you could slide under the seat belt and be seriously or even fatally injured.
Metal objects placed within the line of sight of the antenna will cause decreased performance. When these systems are operating properly, your vehicle will provide excellent performance and fuel economy, as well as engine emis- sions well within current government regulations. Alternate nuts until each nut has been tightened twice. This device may not cause harmful interference, 2. .
Automatic Transmission Shifting from D Drive to P Park or R Reverse or from P or R to D should be done only after the accelerator pedal is released and the vehicle is stopped. If you need a vehicle for a tough job, then there are few choices that could possibly be better than a Jeep to ensure that it is up to the required standard. Fold down the sun visors and move them to the side. Also, a slight amount of airflow may be noticed at the defrost outlet located at the base of the windshield. How- ever, the manufacturer recommends that air conditioning service be performed by dealers or other service facilities using recovery and recycling equipment. Inspect the engine air filter element, replace if necessary.
Reinstall the left sail panel if it was untucked to get the rear window zipper started. Unsnap and remove the black boot cover. Open the header latches and engage the hooks on each side into the windshield slot. We strongly recommend that you take your vehicle to your selling dealer. Yes, curve your finger down when in the hole; then re-install the plug and go wash your hands.