Pry out the light assembly with a flat screwdriver at the side opposite the switch. Press and hold for continuous seek functionality. Copyright © 2005 Ford Motor Company. With the all-door remote entry, press and release again within three seconds to unlock all the doors. Remove the dipstick and inspect the fluid level. Always follow the instructions and warnings that come with any infant or child restraint you might use. Do not put engine coolant in the windshield washer fluid container.
Using a screwdriver remove the trim from the trunk lid. Lower the wheel by turning the jack handle counterclockwise. If the engine idle speed does not slow down automatically, have the vehicle checked. Set the parking brake, depress the clutch and place the gearshift in 1 First. Connect the other end of the positive + cable to the positive + terminal of the assisting battery. Ford Motor Company recommends that all safety belt assemblies in use in vehicles involved in a collision be replaced.
Attach the new blade to the arm loop and pull it into place until a click is heard. Engine oil filler cap 3. The remote entry system activates the illuminated entry feature. Note: If you have to drive a distance to get air for your tire s , check and record the tire pressure first and add the appropriate air pressure when you get to the pump. Remove the jumper cable from the ground metal surface. Ford Motor Company recommends that all safety belt assemblies in use in vehicles involved in a collision be replaced.
If your vehicle gets stuck in mud or snow If your vehicle gets stuck in mud or snow, it may be rocked out by shifting between forward and reverse gears, stopping between shifts in a steady pattern. Note: The seat height adjustment may create a gap between the cushion and the seatback. Carefully pry out the light assembly from the holder with a flathead screwdriver. The childproof locks are located on rear edge of each rear door and must be set separately for each door. Note that the tire size, load index and speed rating for your vehicle may be different from this example.
If you need to arrange roadside assistance for yourself, Ford Motor Company will reimburse a reasonable amount. Determining if the system is operational The supplemental restraint system uses a warning indicator light in the instrument cluster or a back-up tone to indicate the condition of the system. Release the cover at the sides and pull it out horizontally without tilting it. Ford production and aftermarket Motorcraft oil filters are designed for added engine protection and long life. Don't waste time calling around to your local bookstores or waiting for a repair manual to arrive by mail.
Ford or Mercury vehicles customers call 1—800—241—3673;. This operation is considered normal and will fully update transmission operation to its optimum shift feel. Setting speed control The controls for using your speed control are located on the steering wheel for your convenience. Use only fluid that meets Ford specifications. In a crash, one anchor may not be strong enough to hold two child seat attachments and may break, causing serious injury or death.
Wet brakes do not stop the vehicle as quickly as dry brakes. The safety belt warning light illuminates 1-2 minutes and the warning chime sounds 4-8 seconds. To remove a fuse, use the fuse puller tool provided on the power distribution box cover located in the engine compartment. For high speed operation, move control up three positions. Using a fuse with a higher amperage rating can cause severe wire damage and could start a fire. The Focus stays planted and inspires confidence although the four-wheel fully independent suspension allows for noticeable body roll while cornering.
Pull down on the shoulder belt and then grasp the shoulder belt and lap belt together. Also, use the safety belt extension only if the safety belt is too short for you when fully extended. The first few thousand kilometers miles operation, since these, additives may prevent piston ring seating, maintenance and specifications chapter for more information oil, the New Vehicle Limited Warranty includes Bumper-to-Bumper. The load must be placed directly on the dealer installed cross-bars if equipped and luggage rack. Press the switch repeatedly until the moon roof is closed. Have the system checked by your authorized dealer immediately.
Important ventilating information If the engine is idling while the vehicle is stopped for a long period of time, open the windows at least one inch 2. Ford Motor Company has not approved a slingbelt towing procedure. Never remove the coolant reservoir cap while the engine is running or hot. Pull headlamp control towards you to turn foglamps on. Ford recommends the use of a child safety seat having a top tether strap. Refer to the diagram inside the remote entry transmitter for the correct orientation of the battery.
These may include hot wax treatments used by commercial car washes, water repellant coatings, tree sap, or other organic contamination;. Heating with the engine off will drain the battery. This allows your Personal Safety System to distinguish between different levels of crash severity and modify the deployment strategy of the. The speed control may shut off automatically when you are towing on long, steep grades. If the indicator is on, refer to the description in the Warning lights and chimes section of the Instrument Cluster chapter. To disable one-time or deactivate the BeltMinder feature please follow the directions stated below. You should always carry a second key with you in a safe place in case you require it in an emergency.